Mike's Oud Forums
Not logged in [Login - Register]
Go To Bottom

Printable Version  
Author: Subject: Removing Shellac
Jonathan
Oud Junkie
*****




Posts: 1583
Registered: 7-27-2004
Location: Los Angeles
Member Is Offline

Mood: No Mood

[*] posted on 5-26-2008 at 06:22 AM
Removing Shellac


Is there a quick and easy method for removing shellac off of an oud (other than sanding)?
It's a new instrument--nothing rare. Actually, it's one that I am making. I have put several thin coats of shellac on it, but now I want to start over and use a grain filler before applying the shellac. It's not that big of a deal to sand it, but if there is a simpler way, I would like to know.
Thanks a lot.




View user's profile Visit user's homepage View All Posts By User
Jameel
Oud Junkie
*****




Posts: 1672
Registered: 12-5-2002
Member Is Offline

Mood: No Mood

[*] posted on 5-26-2008 at 06:33 AM


I don't think it's worth the trouble Jonathan. Think about it. You want the filler to fill up the pores, and there's no way you're going to be able to remove the shellac from the pores. There's really no need to anyway. When I do a pore filling job I always give the wood a coat or two of thin (1-2lb cut or so) shellac to seal the surface of the wood. This makes the filler easier to scrape off the surface (you only want the filler in the pores), and prevents the filler from muddying the overall look. Depending on how thick your shellac film is, if its thick I would take some 320 to it to get it somewhat level, but not removing it all the way to wood, then go ahead and fill.

If you're set on removing it, denatured alcohol is the stuff. You can also use ammonia, but I'd rather smell the alcohol.




View user's profile Visit user's homepage View All Posts By User
Jonathan
Oud Junkie
*****




Posts: 1583
Registered: 7-27-2004
Location: Los Angeles
Member Is Offline

Mood: No Mood

[*] posted on 5-26-2008 at 06:37 AM


Thanks a lot. You're probably right. It's mulberry, and the wood is awfully porous.
I'm just going to sand it down--not all the way--and then fill.
Thanks!




View user's profile Visit user's homepage View All Posts By User
Dr. Oud
Oud Junkie
*****




Posts: 1370
Registered: 12-18-2002
Location: Sacramento, CA, USA
Member Is Offline

Mood: better than before

[*] posted on 5-27-2008 at 10:26 AM


don't sand it - you'll risk cuting through the shellac to the bare wood and the color will be spotty. Remove shellac with denatured alcohol and 0000 fine steel wool or a plastic scrub pad, wiping off excess with a cloth or paper towel.



View user's profile Visit user's homepage View All Posts By User

  Go To Top

Powered by XMB
XMB Forum Software © 2001-2011 The XMB Group